BRAND

STORY

Fresh and pleasant in-car air.
We suffer from fine dust everyday.
Nowadays, it is a daily routine for everyone to wear a mask outside and check the fine dust level with an app.
‘Third Space’
On average, Koreans spend 2 hours and travel 46.55km in their cars each day.
If you open the window while driving, in-car ultrafine dust (PM2.5) and fine dust
(PM10) will go up 130-fold and 90-fold, respectively.
If you care about your loved ones’ health, you should choose BULLSONE Air Theraphy, a car air purifier capable of generating fresh air in fine dust.
It's not an option but a must-have.
brand stroy img

TECHNOLOGY

TECHNOLOGY img
H13 HEPA filter
Equipped with a H13 HEPA ultrafine dust collection filter that can remove more than
99.95% of 0.3㎛ fine dust & ultrafine dust, Air Theraphy will effectively remove in-car fine
dust & ultrafine dust.

*High efficiency H13 grade HEPA Filter which remove 99.95 % of 0.3 ㎛ sized Ultrafine particle (dust) is applied and it removes polluted air, ultrafine dust inside the vehicle and small room.
- Test Specification: Modified US42 CFR part 84
- Test Conditions: Test particle(0.3 ㎛ NaCl), Wind speed(5.33 cm/sec)
- Testing institution: Korea Institute of Industrial Technology(KITECH)
- 99.95% efficiency is based on the results of the fabric efficiency test conducted in a limited laboratory environment of research institutes in Korea, so efficiency may vary in actual products depending on actual use environment.
Low-noise fan under 45dB
“45 dB or lower” is the noise level of a compact air purifier for CA certification, which is
equivalent to the noise level in a library or quiet office (Source: Ministry of Environment’s
National Noise Data System). Noise level may vary with user or operating environment,
and noise can be reduced by controlling air volume.
CE and FCC certified and obey EU RoHS
Certified the US Federal Communications Commission's FCC certification and the European Union's integrated standard CE certification mark to confirm the electromagnetic suitability of electric and electronic products that do not affect or receive the surrounding environment.

*RoHS(Restriction of Hazardous Substances Directive) is a restriction on the use of 10 specific harmful substances (lead, cadmium, mercury, hexavalent chrome, PBBs, PBDEs, DEHP, DBP, BBP, DIBP) of electrical and electronic products in Europe.

 TECHNOLOGY img

Air Theraphy Multi-action Plus Technology

TEST 1.Smog removal test
In 3 minutes, “the chamber without” Air Theraphy Multi-action Plus showed little change.
However, “the chamber with” Air Theraphy Multi-action had little smog.
*This test was conducted in the lab with certain restrictions for the chamber with smog, and
the test result may vary depending on the actual operating environment.
TEST 2. Smoke laser test
The purpose of this test is to verify the flow of surrounding air when Air Theraphy Multi-action Plus is used.
A laser camera was used to capture the air flow.
As a result, it was verified that smog smoothly emitted through the upper part of Air Theraphy Multi-action Plus while smog flowed into the lower part.
*This test was conducted in the lab with certain restrictions for the chamber with smog, and the
test result may vary depending on the actual operating environment.
TEST 3. Onboard smog removal test
After randomly injecting smog into the car, smog removal effect was checked while Air Theraphy Multi-action Plus is in operation.
In 10 minutes, most smog was gone.
*This test was conducted with smog in the lab with certain restrictions, and the test result may
vary depending on the actual operating environment.
certification table
Category Overview Certificate
Radio Waves Act Registration of Broadcasting and Communication Equipments VIEW PDF
KC EMC Test report(KN41) VIEW PDF
CE KC EMC Test report(KN14-1/2) VIEW PDF
CE EMC Test report(EN50498) VIEW PDF
FCC CE EMC Declaration of Conformity (EN50498) VIEW PDF
CE EMC Test report (EN55014-1/2, EN61000-3-2/3) VIEW PDF
Electric Goods Act CE EMC Declaration of Conformity (EN55014-1/2, EN61000-3-2/3) VIEW PDF
FCC EMC Test report (FCC Part 15 Subpart B) VIEW PDF
TEST 4. Smoke Removal Test
After 3 minutes from starting the test, The Air Theraphy Smart Action “Pre-operation Chamber” had almost no change in smoke compared to the initial stage, but the “Post-operation Chamber” showed the result of the smoke almost removed completely.
*This test was performed inside the chamber by using smoke in a restricted laboratory environment,
and the result may vary according to the actual environment of use.
TEST 5. Filter Performance Test (Smog)
This is the test performed to verify the filter performance when using the Air Theraphy Smart Action. The performance test was conducted to verify the efficiency of the H13-Grade HEPA fabric applied ultrafine dust collecting filer by passing through smog.
* This test was performed inside the chamber by using dust in a restricted laboratory environment,
and the result may vary according to the actual environment of use.
TEST 6. Filter Performance Test (Dust)
After 3 minutes from starting the test, the “General Filter” had almost no change in
dust when compared to the initial stage, but the “H13-Grade HEPA fabric applied
ultrafine dust collecting filter” showed the result of the dust being filtered almost
completely.
*This test was performed inside the chamber by using dust in a restricted laboratory environment,
and the result may vary according to the actual environment of use.
certificatin table
Category Overview Certificate
Radio Waves Act Registration of Broadcasting and Communication Equipments VIEW PDF
KC EMC Test report(KN41) VIEW PDF
KC EMC Test report(KN14-1/2) VIEW PDF
CE CE EMC Test report(EN50498) VIEW PDF
CE EMC Declaration of Conformity (EN50498) VIEW PDF
CE EMC Test report (EN55014-1/2, EN61000-3-2/3) VIEW PDF
CE EMC Declaration of Conformity (EN55014-1/2, EN61000-3-2/3) VIEW PDF
FCC FCC EMC Test report (FCC Part 15 Subpart B) VIEW PDF
FCC Part15 Verification of Conformity (FCC Part 15 Subpart B) VIEW PDF
Electric Goods Act Test report of the Supplier's Declaration of Conformity VIEW PDF
Confirmation for the Supplier's Declaration of Conformity VIEW PDF
CA Certification Indoor Air Cleaner Certificate VIEW PDF

PRODUCT

FAQ

  • Air Therapy Smart Action is automatically turned OFF after 4 hours to prevent battery discharge on the vehicle.

  • Through the air quality indicating LED bar on the upper front side of the product, the air quality level is displayed real-time in 3 stages category. (Good & Normal: Blue / Bad: Yellow / Very Bad: Red)

    (Standard: Alarm system is set in the standard of PM10 (Fine Dust) concentration)

    - Smart Action LED Color Blue: PM10. 0~80 (Blue indicate Good & Normal level in the range of 0 ~ 80, as set by the Ministry of Environment) 

    - Smart Action LED Color Blue: PM10. 81~200 (Due to the recent worsening of air quality, there are frequent indication of Very Bad in the standard of Ministry of Environment, so the value over 200 was randomly set and indicated as Very Bad) 

    - Smart Action LED Color Blue: PM10. 201 or more (Category set randomly as the worst air quality)

  • * Air Therapy Multi Action Plus

    When the red LED on the top is lighted, it shows that the filter needed to be changed soon. Open the rear cover to check the pollution level of the filter to be changed.  

    Press the power button on top for 4 seconds for initialization.

    The filter changing period may vary, depending on the using environment (360 hours in average).


    * Air Therapy Smart Action

    When the red LED bar indicating the air quality is blinking, it shows that the filter needed to be changed soon. Open the top cover to check the pollution level of the filter to be changed. 

    After changing the filter, press the power button for 4 seconds to enable the initialization.

    The filter changing period may vary, depending on the using environment (360 hours in average).

  • Air Therapy Multi Action Plus and Smart Action are mounted with *H13* HEPA fabric applied with ultra-fine dust collecting filter. 

    * H13 refer to the filter fabric grade able to remove 99.95% or more of the 0.3㎛ fine particles.

     ∙ Test Standard: Modified US42 CFR part 84 

     ∙ Test Condition: Test Particle (0.3㎛ NaCl), Wind Velocity (5.33㎝/sec)

     ∙ Test Agency: Korea Institute of Industrial Technology

     ∙ 99.95% efficiency is the test result standard in fabric efficiency performed in a restricted laboratory environment of domestic research institute, and the efficiency may vary in actual environment of use. 

TOP
show video
close